The refiner is intended for wet grinding and defibrating chips or experimental pulp making. It is utilized for developing pulping processes and strength development studies on raw steamed or semi chemically cooked chips, fully cooked pulp, cooked straw, waste paper and many other materials.
The refiner mounted on a study floor frame and fitted with stainless steel disc, one immovable, the other rotating by means of a rotating wheel. The refiner disc are attached with six Allen screw and easily replaceable.

Disc dia 304 mm, speed 1500-3000 rpm. With standard motor and motorized screw feeding arrangements

Technical Data:

Refiner Disc Dia.:  300 mm in six segment

Speed of Refiner:   2000-3000 rpm (main shaft rotational frequency)

Consistency range: 3 to 30%

Parallel degree of both the refiner discs knives are accurate during opening / closing of the cover.

The raw material fuelling mechanism by manual / motorized and easy to clean.

Gap adjustment:  0-20 mm adjustable between the disc with a step of 0.025 mm

Water dilution:   ½” copper pipe line fitting at 3 equal distance for dilution of the material during refining.

Power Supply: Power required to drive the refiner varies 7.5 to 40 Kw

Voltage:    440V, 3Ph, 50 Hz